Ref: GSV-2TSD-DI

1 strain gage amplifier with display and USB interface

High precision table mount amplifier with display
1 analog strain gage input (full/half or quarter)
Sensitivity: 0,35 to 3.5 mV/V
Reset via key
1 analog output -5/+5 VDC, 0-10VDC or 4-20 mA
Sampling: up to 1kHz
Resolution: 24bits
Interface: USB + RS-232
Optional CANopen or Ethernet interface
2 programmable alarms
10-29 VDC power supply
Visualization/recording via GSVmulti software (included)
Labview/Matlab drivers/dlls included

Presentation

The GSV-2TSD-DI is an all-in-one conditioning module for one analog channel:

Signal conditioning for 1 analog channel (force, torque, pressure transducer with strain gage bridge. Full, half or quarter strain gauge bridge with 120/350/1000 Ohm resistors)
Measured value display
1 analog output -5/+5 V
PC / PLC acquisition via RS-232 or CANopen/Ethernet interface (optional)
PC based Data acquisition over USB

Measurement data recording on PC / PLC

GSV-2TSD-DI measurement data acquisition is performed via a serial interface (USB or RS-232). Data are read from the GSVmulti visualization/acquisition software supplied with the amplifier. Acquisition frequency can be set up to 1000 Hz.

The GSV-2TSD-DI module can also be used with Matlab or Labview (drivers supplied) or a utility programmed in C/C++ (dll available).

As an option, the conditioner can be supplied with an RS-232, CANopen or Ethernet interface.

Operation

Sensors are connected via a 12-pin terminal block. The module can be configured using the front panel buttons, or the [GSVmulti] software (https://www.pm-instrumentation.com/gsv-multi-logiciel-de-visualisation-et-dacquisition-de-donnees-pour-conditionneurs-gsv). The module can be powered via the USB port, or via an external 10-28 VDC power supply.