Ref: AMP-SG-MH

Miniature 1-channel Strain Gage Amplifier

Precise single channel miniature amplifier
Provides high level voltage signal output
Externally adjustable shunt resistance and gain
Remote bridge excitation On/Off capability
Remote shunt calibration capability
External mounting bracket available

Description

Michigan Scientific’s AMP-SG-MH Strain Gage Amplifiers are ideal for applications where signal conditioning is needed and space is limited. They are designed to provide signal amplification prior to passing the signal through a slip ring. Superior data accuracy is achieved by locating the signal amplifier on the rotating side of the slip ring. This configuration greatly improves signal quality because the amplifier is located closer to the sensor, which reduces errors due to long lead wires, connector resistance variations, and electromagnetic interference.

These strain gage amplifiers incorporate a precision low drift bridge excitation supply, a stable differential amplifier, and a remotely activated shunt calibration resistor for system span verification. Each amplifier provides strain gage bridge excitation and amplification for one channel. Multiple channel configurations are available.

External mounting brackets for mounting the amplifier to flat surfaces and shafts one inch in diameter or larger are available.

Two versions are available :

AMP-SG-MH-5 : excitation voltage: +/- 2,5VDC
AMP-SG-MH-10 : excitation voltage: +/- 5VDC

Specifications

Parameter	Specification
Bridge excitation voltage	±2.5V, ±5V
Accuracy	0,40%
Temperature coefficient	0,0005%/°C
Gain	100 & 2000 V/V
Output	±10V
Frequency response	1 to 20 kHz
Operating temperature	-40 to +125°C
Weight	11 g

Installation

Specially designed mounting brackets for the AMP-SG-MH are available. These mounting brackets are ideal for mounting the amplifier to flat surfaces and shafts one inch in diameter or larger. They can be easily and securely mounted with bolts or screws, hose clamps, or wide cable ties for a clean and quick mounting solution. Using the mounting bracket eliminates the need for messy adhesives and it traps the amplifier in all six directions.

Electronic type: Signal Conditioning, Amplifier for Slip Ring
Input channels: 1
Input signal type: SG bridge
Analog output signal: ± 10 VDC
Datalogger: no
Tension d'alimentation: 10 Vcc
Connecteur: Terminal 4 pin
Protection Class: IP40
Housing: Plastic