Ref: RIPS P530

Ruggedized angle sensor - +/-50° to +/- 180° - IP67

Measuring range : +/-50° to +/- 180
Non-linearity : 0.25% (0.1% optional)
Bandwidth : 0-10 kHz (0-300Hz in 4-20 mA)
Analogue voltage or current output
MTBF : 350,000 hrs at 104°C
Axial output connector or cable
Mounting : flange or servo motor
Operating temperature: -40°F to 257°F
Construction : Stainless steel
Protection : IP 67
Diameter : 35mm
Shaft diameter : 6mm

Introduction

The RIPS P530 is an accurate and robust inductive angle sensor for scientific and industrial applications. The angle measurement ranges are from 0-100° to 0-360°. Each sensor is calibrated according to the needs of the application (useful range and zero). The sensor is powered by DC voltage, and incorporates conditioning electronics for a voltage or 4-20mA output signal compatible with any analogue acquisition system.

The non-contact, inductive technology offers excellent durability (MTBF > 350,000 hours), which is more robust than an RVDT or potentiometric sensor. Another advantage is the excellent frequency response (> 10 kHz) for high-dynamic control or vibration studies.

The analogue output signal is linear with the absolute position (non-linearity: < ± 0.25° for 100° rotation, optionally reduced to ± 0.1°)

Installation

The sensor body is made of stainless steel. The P530 is mounted by means of a flange. A version for mounting on a servomotor is also available. The use of a flexible coupling is recommended for the shaft connection. The electrical connection is either a connector (IP65) or a cable (IP67). Two potentiometers allow fine adjustment of zero and gain.