Ref: AMP-TCx-M1

Miniature 3-Channel Thermocouple Amplifier

  • Available with 1, 2, or 3 channels
  • Cold junction compensated
  • High-level voltage signal output
  • Precision, low noise, differential amplifier
  • Signal is greatly immune to external noise sources
  • Units available in K, J, T, and E types
  • Wide signal bandwidth, near 1.16 kHz
  • Input signals can be grounded or isolated

Download the product sheet

?

The Miniature Thermocouple Amplifiers AMP-TC-M1 is designed to provide cold junction compensation and amplification of thermocouple sensors. These amplifiers may be used in conjunction with Michigan Scientific slip rings. While all Michigan Scientific slip ring assemblies are manufactured with instrumentation quality rings and brushes, greater data accuracy is achieved by locating the thermocouple amplifier on the rotating side of the slip ring. This configuration greatly improves signal quality because the amplifier is located closer to the sensor, which reduces errors due to temperature gradients across dissimilar metals in the slip ring and magnetic interference.

The Miniature Thermocouple Amplifiers AMP-TC-M1 consists of stable differential amplifiers and a cold junction compensator. Each amplifier provides amplification for one, two, or three thermocouples, depending on the model selected. Amplifiers are available for J, K, E, or T thermocouples. For more channels, more than one amplifier may be used with a single control unit. The amplifiers can be adhered, potted or strapped to many different types of parts. Some Michigan Scientific slip rings are available with the amplifiers built into the rotor.

Available versions

Model Channels Type de Thermocouple
AMP-TC1x-M1 1 x: E, J, K, T
AMP-TC2x-M1 2 x: E, J, K, T
AMP-TC3x-M1 3 x: E, J, K, T
Electronic type
Signal Conditioning, Amplifier for Slip Ring
Input channels
1 , 2 , 3
Input signal type
Thermocouple
Analog output signal
0-10 VDC
Datalogger
non
Tension d'alimentation
± 15 Vcc
Protection Class
IP40
Housing
Plastic

Dimensions

  • Wiring
  • Slip ring
  • Power supply unit

Related products

collecteur tournant mesure

S-Series

Slip Ring - End of Shaft - 4, 6, 8, 10 Circuit - 12000 rpm
collecteur tournant bout d'arbre short S Series

SHORT S-SERIES

Slip Ring – End of Shaft – Compact – 4 to 10 Circuits - 12000 rpm
Conditionneur de mesure

AMP-SG-MH

Miniature 1-channel Strain Gage Amplifier
collecteur tournant

B4-2, B6-2, B8-2

Slip Ring – Tubular – 4, 6 or 8 circuits – 50.8mm – 7000rpm
Phone +33 1 46 91 93 32