Ref: GSV-1H

1- channel straingauge amplifier in DIN rail housing

Taring function via control cable
250Hz filter in the standard design 2.5 kHz or 10 kHz filter optional
Amplification configurable ±10V output signal optional 4...20mA output signal
Supply from up to 8 full bridges at 350 ohm
Connection of half and full bridges as an option

The measuring amplifier GSV-1H is available with voltage outputs ±10V and current output 4...20mA. The current output can be factory configured for automatic zero adjustment to 4 mA (4 mA + 16mA, for "unipolar" measurements), or for an automatic zero adjustment to 12 mA (12 mA + -8 mA, for "bipolar" measurements). Due to the high filter frequency of 250 Hz (2.5 kHz and 10 kHz optional), it is also perfectly suitable for dynamic measurements.

The force sensor is connected to terminals 1 to 4. The voltage supply (11-28 volt) is connected to terminal 5 and 8 (ground). To set to zero, terminal 6 is a brief (ca. 2 s) connected to the voltage supply or a control signal between 5 volt and 24 volt is applied. The status is permanently stored in an EEPROM. Amplification can be switched 1-2-4-10 times via internal jumpers. If the input signal becomes negative, output follows up to 0 mA

Electronic type: Signal Conditioning
Input channels: 1
Input signal type: SG bridge, Voltage (0-10 VDC)
Precision (max error): ≤ 0.1 %
Analog output signal: 4-20 mA, ± 10 VDC
Digital output signal: none
Datalogger: no
Tension d'alimentation: 10 Vcc
Protection Class: IP40
Housing: Plastic