Ref: T12

Rotary torque transducer 0.1 to 5,000 Nm - Square end fittings

Rotary torque sensor
Mechanical connection with square male and female ends
21 measuring ranges from 0.1 Nm to 5000 Nm
Maximal speed: from 1000 to 4,000 rpm depending on the model
Accuracy: 0.25% (0.1% optional)
Output signal: ±5 V (0-10 V optional)
Bandwidth: 1 to 3 kHz
Overload protection: 200%
Supply voltage: 12-28 VDC
Connector output (Connector supplied)
Transmission of the rotor/stator measurement signal without contact
Optional RS-485 or USB output
Optional cable

Introduction

The T12 series of rotary torque transducers is used for measuring rotating torque. Thanks to the square end fittings (1/4", 3/8", 3/4", 1, 1 1/2"), the torque transducer can be installed on the bench or tool very quickly and without additional adapters. The signal transmission between the measuring shaft and the stator is non-contact, providing the advantage of optimised service life and minimised measuring noise.

21 models are available, measuring torques over ranges from 0.1 Nm to 5000 Nm, at speeds up to 4000 rpm for the lowest torques.

The output signal of the T12 torque sensor is amplified (± 5 Vdc). The 8 or 12 pin connector includes the power pins (12-28 Vdc) and the various analog outputs.

Applications

The T12 is intended for characterisation and verification measurements on test benches:

power bench
measurement of the efficiency of electric generators
characterisation of electric motors
Torque measurement on transmission
Torque monitoring

Options and accessories

11 ranges as standard, specific range on request
Cables, displays and acquisition systems can also be supplied as options.

rotatif / statique: rotating
Moment capacity: 0.1 / 0.2 / 0.5 / 1 / 2 / 5 / 10 / 15 / 20 / 35 / 50 / 63 / 100 / 160 / 200 / 300 / 500 / 1000 / 2000 / 3000 / 5000 Nm
Measuring Range (Torque): 0.01 - 1 Nm, 1 - 10 Nm, 10 - 100 Nm, 100 - 1000 Nm, 1000 - 5000 Nm
Montage_Capteur: shaft
Max rotation speed: 4000 rpm
Nonlinearity (% FS): ± 0.25 %
Hysteresis: 0.1 % FS
Signal otuput: 0-10VDC, ± 2,7 VDC
Sortie régime: Non
Tension d'alimentation: 12-29 VDC
Température de fonctionnement: 0 to 60 °C
Connecteur: 8 or 12pin-connector
Protection Class: IP40
: angle output, high accuracy calibration