Ref: SSMF - ±100N à ±10kN - Fatigue

S-Type Force Sensor | Fatigue - Precision | ±100N to ±10kN

Fatigue force sensor
Number of cycles: 10 million
Measurement range: ±100N/±250N/±500N/±1kN/±2.5kN/±5kN/±10kN
Non-linearity: 0.05 % FS
Low drift: 0.025% (20 minutes)
Operating temperature: -55 to 90°C
Deflection at full load < 80 µm
Output 1.5 mV/V
Metric threading
IP65 sealed
Standard 3 m cable output
Tension/compression calibration
TEDS, connector, rod ends, conditioning as options
Material: Aluminium or stainless steel

High-precision sealed S-type force sensor

The SSMF S-type force sensors are high-precision, compact sensors specifically designed for fatigue testing. Accuracy is < 0.1% (non-linearity: 0.05%, non-repeatability: 0.02%, zero sensitivity < ±0.0015%/°C), and the SSMF is rated for > 10^7 cycles at full load.

Specifications

Ranges: ±100N/±250N/±500N/±1kN/±2.5kN/±5kN/±10kN
Non-linearity: ± 0.05%
Hysteresis: ± 0.03%
Deflection: 0.05 to 0.08 mm
Output: 1.5 mV/V
Overload capacity: 150%
Natural frequencies: 1.5 to 3.3 kHz depending on model
Deflection < 80 µm

Installation

Force is applied via two M6 or M12 threaded holes on either side of the sensor. The SSMF is supplied with a 3 m cable (alternative: with a connector), and the operating temperature range is -55 to +90°C. The sensor body, made of aluminium or stainless steel depending on the measurement range, is IP65 sealed.

Conditioning and acquisition

The SSMF S-type sensor is powered by 5 to 15 Vdc. A complete and configured measurement chain can be obtained by adding a display, conditioner, or acquisition module. See our selection:

Display: allows direct measurement visualisation in engineering units, threshold management, max-min values, and amplified output.
Conditioner: enables conversion of the measurement signal to voltage or current (±5, ±10 Vdc, 0-10 Vdc, or 4-20 mA).
Acquisition systems: transmits measurement signals to a PC, programmable logic controller, recorder, or SCADA-type supervision application.